Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 04/06/2014 at 12:10 pm in reply to: Technical Section ? #4472
    yukiegabeva
    Participant

    Hi Oliver,

    Thanks for the information I have tried the wood dust trick before though it always seems to go very dark in colour.

    I’m going to Beale Park boat show this weekend so will see what’s on offer there.

    Could you check to see if there is a problem with the link you gave re rigging alternatives as every time I try I get a page not found message.

    Regards

    Nick Jones

    11/05/2014 at 8:58 am in reply to: Stopper or putty to hide wood screws #4301
    yukiegabeva
    Participant

    Thanks Steve now you mention it I’ve heard of Brummer but I think I shall be going down the suggested epoxy route as I have some of that colloidal silica you mention.  I may also buy a new plug cutter as the one I have is to small for the diameter of the existing counter sink of the screws. I have also just taken delivery of a product called “Milliput” which is a two part epoxy putty that comes in the form of two sticks that when combined form a thick paste which can be moulded before it goes hard, I have the terracotta version which looks to be about the right colour. I will post the results in due course.

    Thanks again for your help,

    Regards  Nick.

    01/05/2014 at 5:13 pm in reply to: Technical Section ? #4164
    yukiegabeva
    Participant

    Thanks Dale,

    It seems there was an access problem that has now been sorted out thanks to Hugh Brazier.

    Apparently my user I.D. caused some issue though I’m not sure why it’s only the combined names of my two GP’s.

    Regards Nick.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)